D4N-6D2HR INSTRUCTION sheet ()

Actuator: Roller plunger.
Conduit size: 2-conduit; G1/2.
Built-in switch mechanism: 1NC/1NO (Slow-action).
Popular Safety Limit Switches.
Providing a Full Lineup Conforming to,
International Standards.
Lineup includes models with 1NC/1NO, 2NC, 2NC/1NO and,
3NC contact forms.
(Slow-action models with MBB contacts are available D4N-6D2HR INSTRUCTION sheet. )
M12-connector models are also available, saving on labor and,
simplifying replacement D4N-6D2HR
Standardized gold-clad contacts provide high contact reliability.
Can be used with both standard loads and microloads.
Conforms to EN115-1, EN81-1, and EN81-2 (slow-action models only).
Certified standards: UL, EN (TÜV), and CCC. Specifications: Outputs; NPN (- common);
16 points D4N-6D2HR INSTRUCTION sheet.
I/O connections: M3 screw terminals.
Rated internal circuit power supply voltage:
Supplied from Basic Unit.
I/O power supply voltage: 24 VDC.
A Smart Slave with a 3-tier Terminal,
Block That Means Wiring Locations,
Are Easy to Understand with No,
Sharing of Terminals.
Easy wiring with no sharing of terminals.
Easy-to-understand wiring locations.
No relay terminal block terminals required D4N-6D2HR INSTRUCTION sheet.
Detachable cassette-type circuit sections. Measurement range: 5 mm.
Output specifications: B7A serial communications output (See note 2.).
Actuator: Flat type (See note 1.).
Resolution: 1 µm.
Contact Displacement Sensor with Built-in.
Amplifier That Enables In-line Measurement.
of a Wide Range of Objects with a Low.
Operating Force.
Works with a low operating force (0.29 N) to detect a wide vari,
ety of objects including glass, plastic, and rubber objects.
Models with digital output for B7A Units and models with 4- to,
20-mA linear output corresponding to the 0- to 5-mm measure,
ment range are available.
Models with ball-, flat-, or pin-type actuators are available for a,
wide variety of objects.
The XS3 Sensor I/O Connector makes Sensor connections simple. Ratings: 0.1 A at 125 VAC.
Cable: VCTF oil-resistant cable*.
Actuator: Pin plunger.
Cable length : 3m.
Compact Limit Switch That''s Also.
Thin and Highly Sealed.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models.)
Sealing characteristics that meet IEC IP67 degree of protection.
Triple-sealed construction:
Plunger section sealed via nitrile rubber packing seal and,
diaphragm; switch section sealed via nitrile rubber cap;
cable entrance sealed via encapsulating material.
Caable lengths of 3 and 5 m available on standard models D4N-6D2HR Manual.
Models also available with UL and CSA-certified cables.
Multiple mounting possible with Switches with Plungers.
Models with red LED indicators added to series for easy,
connfirmation of operation D4N-6D2HR Manual.
(Set by default to light for non-operation.)
VCTF oil-resistant cables with CE marking.
(Applicable only to standard models.)