D4NL-2HFA-BS INSTRUCTION sheet ()

Ratings: 3 A.
Actuator: Hinge lever.
Terminals: Solder terminals.
Contact form: SPDT.
Sealed Subminiature Basic.
Switch Conforming to IP67.
(Excluding the terminals on terminal models).
Use of epoxy resin assures stable sealing,
making this switch ideal for places subject to,
water spray or excessive dust D4NL-2HFA-BS INSTRUCTION sheet.
Ideal for automobiles, automatic vending,
machines, refrigerators, ice-making equipment,
bath equipment, hot-water supply systems, air,
conditioners, and industrial equipments, which,
require high environmental resistance D4NL-2HFA-BS
Models available with UL, CSA, and VDE safety,
standard compliance. Ratings: 1 A at 125 VAC.
LED indicator: Without indicator.
Actuator: Crossroller plunger D4NL-2HFA-BS INSTRUCTION sheet.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick with Connector.
New center roller lever models that enable ganged mounting.
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection.
Operation indicators available for easy monitoring,
(standard indicator is lit when Switch is not operating) D4NL-2HFA-BS INSTRUCTION sheet.
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models.) Release Key Type: Special (resin).
Wiring method: Connector.
Solenoid voltage/Indicator: 24VDC (Orange).
Lock and release type: Solenoid lock Mechanical release.
Contact configuration (door open/closed detection switch,
and lock monitor switch contacts): 5-contact Model,
Insert the built-in switch (E, F, G or H) into the blank @.
Conduit size (See Note.): 1/2-14NPT.
World''s smallest Class 6-contact Guard Lock.
Safety-door Swwitch D4NL-2HFA-BS Manual.
.
Wiring time is reduced with two types of wiring.
methods capable of one-touch attachment and removal.
A wide variety of built-in switches can be used for various devices.
(4-, 55-, and 6-contact models are available) D4NL-2HFA-BS Manual.
Key holding force of 1,300 N.
It is possible to change the key insertion point.
without detaching the head.