DRT2-ID16ML INSTRUCTION Manual ()

Actuator: Roller lever (resin lever, resin roller).
Conduit size: 2-conduit; M20.
Built-in switch mechanism: 2NC/1NO (Slow-action).
Popular Safety Limit Switches.
Providing a Full Lineup Conforming to,
International Standards.
Lineup includes models with 1NC/1NO, 2NC, 2NC/1NO and,
3NC contact forms DRT2-ID16ML INSTRUCTION Manual.
(Slow-action models with MBB contacts are available.)
M12-connector models are also available, saving on labor and,
simplifying replacement DRT2-ID16ML
Standardized gold-clad contacts provide high contact reliability.
Can be used with both standard loads and microloads.
Conforms to EN115-1, EN81-1, and EN81-2 (slow-action models only).
Certified standards: UL, EN (TÜV), and CCC. Power supply voltage: 24 VDC DRT2-ID16ML INSTRUCTION Manual.
Connects to a Total Maximum of Eight,
Digital I/O, Analog I/O, and Relay Output,
Units Compatible with MULTIPLE I/O,
TERMINAL.
Allows flexible combinations of I/O points.
Covering a total cable length of 3 m.
DIN track mounting. Ratings: Standard load; 5 A at 250 VAC, 4 A at 30 VDC.
Cable: SJT(O) cable *3.
Actuator: Center roller lever.
Cable length : 3 m.
Compact Limit Switch That''s Also DRT2-ID16ML INSTRUCTION Manual.
Thin and Highly Sealed.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models.)
Sealing characteristics that meet IEC IP67 degree of protection.
Triple-sealed construction:
Plunger section sealed via nitrile rubber packing seal and,
diaphragm; switch section sealed via nitrile rubber cap;
cable entrance sealed via encapsulating material.
Cable lengths of 3 and 5 m available on standard models.
Models also available with UL and CSA-certified cables.
Multiple mounting possible with Switches with Plungers.
Models with red LED indicators added to series for easy,
confirmation of operation.
(Set by default to light for non-operation.)
VCTF oil-resistant cables with CE marking.
(Applicable only to standard models.)Type: Welding / wire type, M3 screw mounting.
Drive rod: needle shaped button type.
Terminal specification: welding.
Contact specificattions: 1c DRT2-ID16ML Manual.
The minimum size of the long stroke type can be reliably switch
The body part size is 78% of the previous generation product, which is beneficial to the miniaturization of the equipment.
No swing bars are also used ffor easy long stroke specifications (OT reference value: 1 DRT2-ID16ML Manual. 4mm).
Without harmful substances to the environment, the lead type has also been lead-free.