E2S-Q12 INSTRUCTION sheet ()

E3JM-R4M4T detection method: Regression reflection type with M.S.R. function,
Connection: terminal plate,
Detection range: 4m.
Output status: ON into the light; light shading ON; switch conversion type.
Output: relay. Function: timer,
2 types of cost reductionName: Temperature Controller (See note 1 E2S-Q12 INSTRUCTION sheet. ).
Power supply: 24 VDC.
No. of control points: 2.
Control output: Transistor output E2S-Q12
Auxiliary output: Transistor output: 2 pts (sourcing).
Functions: Heater burnout alarm (See note 3.), Heating or heat/cool,
control is selectable (See note 4.)Event input: 1 point per Unit.
Communications functions: RS-485.
Input type (See note 5.): Thermocouple.
New DIN Track Mounting Temperature.
Controller E2S-Q12 INSTRUCTION sheet.
Two channels of temperature control available despite width of,
only 22.5 mm.
The Temperature Controller itself can be replaced without,
changing terminal wiring.
Use in combination with a compact Setting Display Unit to,
reduce communications programming requirements.
Front-panel LED indicators for easy operation monitoring.
Power supply and communications wiring not required between,
Units when mounted side-by-side E2S-Q12 INSTRUCTION sheet.
CompoWay/F communications protocol supported.
UL, CSA, and CE Marking compliance. Appearance: Noise-resistant Models, Unshielded 34 dia.
Sensing distance: 20 mm [3 to 20 mm *].
Model: Output configuration, AC/DC 2-wire;
Operation mode, NO.
Long-distance Capacitive Sensor.
with Adjustable Sensitivity.
CE Marking for DC 3-wire models and AC/DC 2-wire models.
Noise-resistant models are also available for environments with,
strong noise. Size: 48 x 96mm.
Ontology: terminal type, analog input type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 3 points.
Heater with broken wire, SSR fault, heater over current detection function /ES1B power supply: single phase heater with detection function.
Event entry point: 2.
Transfer output: -.
Communication: -.
The general temperature controller 96mm, 48 * 96mm square has been upgraded to improve the performance and function of /.
Indicates that the accuracy of the upgrade, increase the function of prevention and maintenance, further enhance the performance.
Add PV/SV state display function, to see the state of the thermostat
(automatiic / manual, RUN/STOP, alarm), interactive display PV/SV E2S-Q12 Manual.
Increase the number of control output ON/OFF counting function, can prevent the maintenance of temperature controller internal relay.
Increased the 3 segment display, which cann display the current value / target / operation E2S-Q12 Manual.
Increased the PF key, the distribution of automatic / manual, RUN/STOP, etc., can be a key operation.