E3S-RS30C4-30 INSTRUCTION sheet ()

Appearance: Horizontal type.
Sensing method: Convergent reflective type.
Sensing distance: 2 to 5 mm.
Output type: NPN output.
Output configuration: Light-ON.
Accurately detects objects placed in,
front of shiny Background.
A shiny background can be used as long as the distance between,
the sensor and the background is 20 mm or more E3S-RS30C4-30 INSTRUCTION sheet.
Detects minute objects such as a 0 E3S-RS30C4-3005-mm-dia. pure copper wire.
Small dispersion in sensing distance.
Light modulation effectively reduces external light interference.
Wide operating voltage range: 5 to 24 VDC. Appearance: Shielded, M30.
Sensing distance: 10 mm.
Output configuration : DC 2-wire.
Operation mode: NO.
Inductive Profoximity Sensor with E3S-RS30C4-30 INSTRUCTION sheet.
Chemical-resistant Fluororesin Case.
Housing and mounting are made of Fluororesin resistant to chemicals.
Maximum sensing distance: 10 mm. Size: M8(Stainless steel)(See note 2.); Double; Unshielded.
Sensing distance: 4 mm.
Connecting method (See note 1.): M8 Connector (3-pin).
Body length: Short.
Output configuration: PNP.
Operation mode NC.
A new generation in global applications E3S-RS30C4-30 INSTRUCTION sheet. Appearance: Shielded, M12.
Sensing distance: 4 mm.
Output: NPN.
Model: Operation mode NC.
Aluminum and Iron Both.
Detectable from Long Distances. Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: RS-232C.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) maakes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E3S-RS30C4-30 Manual.
Through the infrared port can be carried out from the frront of the communication E3S-RS30C4-30 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.