E3Z-G82-M3J INSTRUCTION sheet ()

Sensing method: Through-beam.
Connection method: Pre-wired Connector (M8, 4 pins).
Sensing distance: 25 mm.
No. of opti- cal axes: 1.
Model: NPN output.
Photoelectric Sensor with Grooved.
Design and Easy Settings .
Groove-type Sensor with groove width of 25 mm.
Models are available with one or two light axes E3Z-G82-M3J INSTRUCTION sheet.
Models are available with M8 pre-wired connectors E3Z-G82-M3J Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater E3Z-G82-M3J INSTRUCTION sheet.
Event entry point: 4.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: -.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved E3Z-G82-M3J INSTRUCTION sheet.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contacct output E3Z-G82-M3J Manual.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type. E32-DC200F4R type: standard type; soft (new standard),
Specialty: M3 screw ((small) with casing,
Bending radius (mm): R; R1 E3Z-G82-M3J Manual.
Standard test object (minimum test object) (mm) 1: (0.005),
Fiber element for meeting diversified needs