CP1E-N60DT-D PROGRAMMING MANUAL (Software)

Name: CS1D Expansion Backplane.
Specifications: Applicable systems,
Duplex CPU, Single I/O Expansion System only;
Number of Power Supply Units, 2 Units max.
(for duplex operation);
Number of I/O Units, 9 Units max.
Current consumption: 5V system, 0.28A;
26V system, --.
Standards: UC1, N, L, CE CP1E-N60DT-D PROGRAMMING MANUAL.
Redundant CPU Units , Power Supply Units ,
Communications Units ,
and Expansion I/O Cables CP1E-N60DT-D Model : C500-II101.
Necessary to connect Expansion I/O Backplane.Model : C500-MR831.CVM1-LK SYSMAC BUS CVM1 PCLINK MODULE CVM1-LK401.Name: Bit Slave Units with e-CON Connectors.
Specifications: Inputs; 2 inputs; PNP.
Simple and Intelligent Bit Slaves,
with Industry-standard e-CON connectors.
Slave Units capable of 2-point bit-level distribution CP1E-N60DT-D PROGRAMMING MANUAL.
The I/O power supply is supplied from the communications,
power in the previously connected flat cable, and has a,
short-circuit detection function for protection.
Industry-standard e-CON connectors.
Short-circuit protection safeguards the network,
from I/O short circuits.
Simple communications connections,
with flat cable and connectors CP1E-N60DT-D PROGRAMMING MANUAL.
Bit-level distribution to support,
essentially any application. Unit type: CJ1 CPU Bus Units.
Product Name: Position Control,
Unit with MECHATROLINK-II interface.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder programming.
Control mode: Position control,
speed control or torque control;
No. of axes: 16 axes.
No. of unit numbers allocated: 1.
Current consumption : 5V, 0.36A; 24V,--.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
andd Batch Management CP1E-N60DT-D Manual.
Control Servos for up to 16 axes in,
a motion network with one Position,
Control Unit that supports MECHATROLINK-II.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association. CPPU Unit: Units with 10 I/O points CP1E-N60DT-D Manual.
I/O terminal block.
Inputs: 6 inputs.
Outputs: 4 outputs.
Input type: 24 VDC.
Output type: relay.
Internal clock: --.