CS1G-CPU42-V1 OPERATION MANUAL ()

Unit type: CJ1 CPU Bus Units.
Product Name: Serial Communications nits.
Specifications:Communications Interface,
2 RS-232C ports;
Communications functions,
The following functions can be,
selected for each port:
Protocol macro Host Link,
NT Links (1:N mode)Serial Gateway,
No-protocol Modbus-RTU Slave CS1G-CPU42-V1 OPERATION MANUAL.
No. of unit numbers allocated: 1.
Current consumption : 5V, 0 CS1G-CPU42-V128A; 24V,--.
Standards: UC1, N, L, CE.
The Serial Communications Units That Enable,
High-speed Connections with External Devices.
Each Serial Communications Unit provides two,
serial communications ports: RS-232C and,
RS-422A/485, and the serial communications,
mode can be set separately for each port from,
Protocol Macro, Host Link, NT Link,
Serial Gateway, and No-protocol CS1G-CPU42-V1 OPERATION MANUAL. Name: CS1D Expansion Backplane.
Specifications: Applicable systems,
Duplex CPU, Dual I/O Expansion System only;
Number of Power Supply Units,
2 Units max. (for duplex operation);
Number of I/O Units, 9 Units max.
(Slot number 0 is reserved for an,
I/O Interface Unit).
Current consumption: 5V system, 1.21A;
26V system, --.
Standards: UC1, CE CS1G-CPU42-V1 OPERATION MANUAL.
Redundant CPU Units , Power Supply Units ,
Communications Units ,
and Expansion I/O Cables. Number of outputs: 32 pts.
Max. switch-ing capacity: 0.5 A at 24 V DC.
External connector: Connector.
Weight: 210 g max.Model: C200HS-MP16K.
Capacity: 16K words/32K words.Unit type: CJ1 CPU Bus Units.
Product Name: Position Control,
Unit with MECHATROLINK-II interface.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder programming.
Control mode: Position control,
speed control or torque control;
No. of axes: 16 axes.
No. of unit numberss allocated: 1 CS1G-CPU42-V1 Manual.
Current consumption : 5V, 0.36A; 24V,--.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes in,
a motion network with one Position,
Control Unit that supports MECHATROLINK-II CS1G-CPU42-V1 Manual.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.