Optical system: diffuse type.
Detection distance: 50 positive and negative 5mm.
Beam shape: linear beam.
Beam diameter: 900mm * 60 M.
Resolution: 0.8 M.
Cable length: 0.5m.
Sensing method: Diffuse-reflective Sensors.
Appearance: Horizontal.
Connection method: Connector (M12).
Sensing distance: 200 mm .
Functions: --.
Model: NPN output.
Ordering Information.
Built-in Amplifier Photoelectric Sensors. V520-R221SH type: bar code reader side,
Ultra small CCD type
The fastest sorting speed of 500 scans per secondSize: M8, Non-shielded ZS-LD50 0.5M.
Sensing distance: 4
ZS-LD50 0.5M0 mm.
Connection: M8 connector (3-pin).
Body material: Stainless steel.
Thread length (overall length): 27 (39).
Output configuration: PNP.
Operation mode NO.
Safe Mounting with Greater.
Sensing Distance.
Ensures a sensing distance approximately 1.5 to 2,
times larger than that of any conventional OMRON Sensor ZS-LD50 0.5M.
Problems such as the collision of workpieces are eliminated.
Full range of standard sizes (M8, M12, M18 and,
M30; both long and short barrels).
Modular construction simplifies customization. Appearance: 6.5 dia.
Sensing distance: 4 mm.
Connecting method: M8 Pre-wired Connector Models (0.3 m).
Cable specifications: PVC (oil-resistant).
Operation mode: NC.
Wire color /pin arrangement: 1: +V, 3: 0 V, 4: Control output ZS-LD50 0.5M.
Model: NPN output.
Ultra small size, but surprisingly easy installation!
With the addition of M4, 5.4-dia., 6.5-dia. size, unshielded,
pre-wired connector model, and connector model, a total of,
108 model variations are available.
High-speed response frequency stably detects moving,
objects: 5 kHz max.
Four indicator lamps for easier indicator positioning.
Special mounting brackets reduce time and efforts for,
installation.
Protective Stainless-steel Spiral Tube against wire,
breakage is available (M4, M5 only).
Models also available with standard cables that are 5 m long,
or with robot (bbending-resistant) cables ZS-LD50 0.5M. Mounting method.
Hook the upper protruding portion,
of the Slit to the upper indented,
mounting portion of the Sensor,
and adjust the position of the Slit,
so that the Slit will be in parallel to,
the leens side of the Sensor ZS-LD50 0.5M.
Press the lower protruding portion,
of the Slit onto the indented,
mounting portion of the Sensor,
until the Slit snaps in.