CP1L-M60DT-D REFERENCE MANUAL (Communications Commands)

4 Axis Position Control and Comprehensive Programmable Controller.
The CP1H-X with pulse outputs for 4 axes.
The CP1H-Y with 1-MHz pulse I/O.
The CP1H-XA with pulse outputs for 4 axes and built-in analog I/O. Name: Three-tier Screw Terminal Block.
Specifications: Outputs; 8 outputs; NPN;
With Short-circuit and,
Disconnected Line Detection CP1L-M60DT-D REFERENCE MANUAL.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet CP1L-M60DT-D
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site CP1L-M60DT-D REFERENCE MANUAL.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Model: C200H-MR833.
Description: RAM, 8K words, battery back-up.with clock(CPU21, CPU23 only).Name: Three-tier Screw Terminal Block.
Specifications: Outputs; 16 outputs; PNP;
With Short-circuit and,
Disconnected Line Detection CP1L-M60DT-D REFERENCE MANUAL.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Meet the standard interface IEEE-488-1978 (GP-IB).Provided with a 2-m cable for ladder programming.Connecting I/O control module and interface module.
Cable length: 0.3 m.Name: Repeater Unit.
Specifications: A sub-trunk line can be,
connected downstream,
(for trunk-branch line configuration),
or further branching is enabled downstream,
(for configurations with no wiring restrictions),
in the same way as for a Master Unit.
A Repeater Unit can be used to branch,
the trunk line and increase the,
number of connected Units,
as well as to extend the length of the,
communications line.
Standards: CE, U, U1, L, N.
Simple and Intelligent Bit Slaves,
with Industry-standard e-CON connectors.
Slave Units capable of 2-point bit-level distribution.
The I/O power supply is supplied frrom the communications,
power in the previously connected flat cable, and has a,
short-circuit detection function for protection CP1L-M60DT-D Manual.
Industry-standard e-CON connectors.
Short-circuit protection safeguards the network,
from I/O short circuits CP1L-M60DT-D Manual.
Simple communications connections,
with flat cable and connectors.
Bit-level distribution to support,
essentially any application.