E2V-X10C1 INSTRUCTION sheet ()

Appearance: Shielded, M18.
Sensing distance: 8 mm.
Output: PNP.
Model: Operation mode NO.
Aluminum and Iron Both.
Detectable from Long Distances. Sensor type: Retro-reflective with MSR function.
Sensing distance: 0.1 to 4 m with E39-R1S.
Connection method: pre-wired.
Model: NPN output.
A new generation in sensing performance E2V-X10C1 INSTRUCTION sheet.
Simplicity.
Simple selection.
Simple installation E2V-X10C1
One family for all.
All standard applications covered.
A wide variety of models.
Models designed for special applications.
Non-stop detection.
High quality and reliability.
High EMC protection.
High light immunity.
Robust and waterproof housing. E32-R21 type: special beam; Coaxial / spot,
Specialty: M6 screw,
Bending radius (mm): R25 E2V-X10C1 INSTRUCTION sheet.
Standard test object (minimum test object) (mm) 1: (0.005),
Fiber element for meeting diversified needsDetection methods: on the radio type (projector + optical device).
Connection mode: lead type (2 m)
Detection distance: infrared 20m.
Output mode: PNP output.
Optical projector: 2M E3Z-FTP12-L.
Optical device: 2M E3Z-FTP12-D. Size: 96 x 96mm.
Category: power AC100 ~ 240V with E2V-X10C1 INSTRUCTION sheet.
Shell color: black.
Control output 1: built-in SSR output.
Control output 2: built-in SSR output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: -.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to checkk the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV E2V-X10C1 Manual.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output E2V-X10C1 Manual.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type.