CPM1A-20CDT-A-V1 STARTUP GUIDE MANUAL ()

Model: C200H-B7A21.
I/O points: 16 output points and 16 input points or 15 input points + 1 error
input.
Weight: 300g max.100 to 120/200 to 240 VAC (switchable), APF/PCF.Unit type: CS-series Special I/O Units.
Product name: Analog Input Units.
Specifications: I/O points, 16 inputs;
Signal range selection,
Set separately for each input;
Signal range, 1 to 5 V, 0 to 5 V,
0 to 10 V, -10 V to 10 V, 4 to 20 mA;
Resolution, 1/8,000 (Settable to 1/4,000);
Conversion speed, 250 s/point max CPM1A-20CDT-A-V1 STARTUP GUIDE MANUAL CPM1A-20CDT-A-V1
(Settable to 1 ms/point).
Externa connection, MIL connector.
Current consumption: 5V, 0.15A; 26V, 0.06A.
Standards: UC1, CE.
For Various Analog I/Os.
Analog Input Units for converting,
analog input signals into binary data CPM1A-20CDT-A-V1 STARTUP GUIDE MANUAL.
Analog Output Units for converting ,
binary data into analog output signals. Supply voltage: 100 to 120 or 200 to 240 VAC, 50/60 Hz
Output capacity: DC5V, 6.5ACommonly used with other Communications Units.Model: CPM2C-24EDTC. Units with 24 I/O points
2 Fujitsu connectors.
Inputs: 16 inputs.
Outputs: 8 outputs.
Input type: 24 VDC.
Output type: sinking transistor CPM1A-20CDT-A-V1 STARTUP GUIDE MANUAL. Name: Three-tier Screw Terminal Block.
Specifications: Inputs; 8 inputs; NPN;
Without Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Name: Repeater Unit.
Specifications: A sub-trunk line can be,
connected downstream,
(for trunk-branch line configuration),
or further branching is enabled downstream,
(for configurations with no wiring restrictions),
in the same way as for a Master Unit.
A Repeater Unit can be used to branch,
the trunk line and increase the,
number of connected Units,
as well as to extend the length of the,
communications line.
Standards: CE, U, U1, L, N.
Simple and Intelligent Bit Slaves,
with Industry-standard e-CON connectors.
Slave Units capable of 2-point bit-level distribution.
The I/O power supply is supplied from tthe communications,
power in the previously connected flat cable, and has a,
short-circuit detection function for protection CPM1A-20CDT-A-V1 Manual.
Industry-standard e-CON connectors.
Short-circuit protection safeguards the network,
from I/O short circuits CPM1A-20CDT-A-V1 Manual.
Simple communications connections,
with flat cable and connectors.
Bit-level distribution to support,
essentially any application.